ProClip DC Step Down Converter with 6 ft. Barrel Jack Cable

ProClip DC Step Down Converter with 6 ft. Barrel Jack Cable

DC power converter. Typically used in forklifts or other 48V vehicles to step voltage down for ProClip power supplies. It is designed for 48 VDC but can tolerate dips and spikes from 18VDC and up to 60VDC and it will continue to output clean and consistent power.

Features

• For installation into vehicle power supply
• Works with forklifts and other vehicles that use up to 48 volt direct current (VDC) power systems.
• Input surge voltage of up to 60 VDC.
• Converts 48V, 36V, 24V, and 18V systems to 12V
• 36W continuous output

Specifications

• Input Voltage: 48Vdc nominal (12V to 60V)
• Output Voltage: 13.6Vdc +/-10%
• Continuous Current Rating: 13.6V at 3A
• Intermittent Current Rating: 13.6V at 6A for a maximum of 2 minutes followed by 8 minute rest
• Transient Voltage Protection: Meets ISO7637-2 International Standard for 24Vdc Commercial Vehicles
• Electro Static Voltage Protection: Meets ISO10605, ISO14982, >8kV contact, 15kV discharge
• Output Noise: <50mV pk-pk at continuous load
• Off load current (quiescent current): <30mA. If connected to the battery, but not powering any equipment
• Power Conversion Efficiency: Typically 80%
• Operating Temperature: -25°C to +30°C to meet these specs. +30°C to +80°C de-rate linearly to 0A
• Storage